Bertazzoni Insert Range Hoods

Bertazzoni Insert Range Hoods at Plesser's Appliances

Bertazzoni ventilation inserts, available at Plesser's Appliances, install inside a custom hood enclosure built by your millworker or mason, so only the working interior is Bertazzoni. Built in Emilia-Romagna since 1882, inserts are the route to a hood finished in plaster, wood, stone, or metal that matches the room rather than reading as an appliance.

Bertazzoni Performance Inside Your Own Enclosure
An insert delivers the capture area, filtration, lighting, and controls of a Bertazzoni hood without dictating the exterior. The surround is built to your design — a plastered chimney, a paneled wood canopy, a metal hood fabricated to match cabinetry hardware. This is how a high-output kitchen gets ventilated without a stainless box on the wall.

Enclosure Dimensions Come First
The insert determines the interior dimensions the enclosure must accommodate, including depth for the unit and access for filter service. This is the most common source of trouble on an insert job: the surround gets built, then the insert does not fit or the filters cannot be reached. Get the insert specification to your millworker before the surround is fabricated.

Sizing Capacity to the Cooking Surface
Capacity must be matched to the output of the range or rangetop below, and Bertazzoni brass power burners produce far more heat, moisture, and grease-laden air than standard residential burners. Undersized ventilation shows up as lingering odor and grease film. Ask about the recommended capacity for your specific cooking surface rather than working from width alone.

Blower Options and Noise
Blowers may be internal to the insert, in-line within the duct run, or exterior-mounted, and placement affects both delivered capacity and how much noise ends up in the room. On a high-capacity installation, moving the blower out of the enclosure is the most effective way to quiet it. Confirm what blower is included versus ordered separately.

Duct Routing, Make-Up Air, and Installation Planning
Duct diameter, run length, and elbow count all reduce delivered capacity, and high-capacity installations may require a make-up air system under mechanical code — coordinate that with your HVAC contractor rather than at appliance installation. Mounting height and capture width also need settling before framing. Talk to the team at Plesser's Appliances about insert sizing and blower selection alongside your range decision.