Sub Zero Outdoor Refrigerators

Sub-Zero Outdoor Refrigerators at Plesser's Appliances

Sub-Zero outdoor refrigeration, available at Plesser's Appliances, brings food and beverage storage to a patio kitchen, poolside bar, or grill station. Built in Wisconsin by Sub-Zero Group, these units are constructed and rated for outdoor installation and are designed to coordinate with Wolf outdoor grills, warming drawers, and storage in the same run.

Built and Rated for Outdoor Use
An outdoor unit is not an indoor unit in a different finish. Stainless construction is tested to resist corrosion and temperature extremes, with sealed components and weather-rated seals for permanent outdoor installation. Confirm the specific rating and any covered-installation requirement on the spec sheet — most outdoor refrigeration is rated for use under cover rather than full exposure to rain and direct sun.

Holding Temperature in Summer Heat
Outdoor refrigeration works against ambient heat and, near a grill, radiant heat as well. Sub-Zero's microprocessor-controlled system holds its setpoint closely rather than drifting as conditions rise, and magnetic seals lock conditions in each time the door or drawer closes. Confirm the rated ambient operating range for your climate and siting.

Door and Drawer Configurations
Outdoor refrigeration is offered in undercounter door units and refrigerator drawers. Drawers eliminate door swing entirely, which is what makes them workable in an island or beside a grill where a hinged door would block the cook, with contents visible from above rather than stacked behind one another. Which configurations are current varies — confirm before finalizing the layout.

Coordinating the Outdoor Kitchen
Because Sub-Zero outdoor refrigeration is designed around common heights and finishes with Wolf outdoor cooking equipment, the full elevation can be laid out as one installation rather than assembled unit by unit. Refrigeration, grill, warming, and storage should be dimensioned together while the island is still on paper.

Installation, Electrical, and Seasonal Planning
Outdoor installation requires a GFCI-protected dedicated circuit, clearance maintained for ventilation within the enclosure, and cutouts planned before masonry or framing is finished. Coastal and poolside installations warrant attention to construction specification, since salt air and chlorine shorten the life of standard stainless. Talk to the team at Plesser's Appliances about widths, ambient ratings, cover requirements, and rough-in before construction begins.